Jeddah headquarters, serving Riyadh, Dammam and Makkah
Services
Eight service lines covering heat rejection, heat exchange, HVAC and MEP, rotating plant, boilers and protective linings, all delivered by one accountable team.
Design, fabrication and re-tubing
Thermal design, fabrication and field re-tubing of shell and tube exchangers for process duty, sized against your real operating conditions rather than a catalogue selection.
Selection, supply, installation and maintenance
Evaporative condensers and closed-circuit cooling towers for refrigeration and process duty: high heat rejection per square metre, with far lower water consumption than an open circuit.
Evaporators, radiators and dry coolers
Air-cooled condensers, evaporators, radiators and dry coolers for sites where water is scarce, expensive, or simply not worth the treatment burden.
Design, supply, install and commission
Mechanical, electrical and plumbing engineering for commercial and industrial facilities, from load calculation and system design through installation, commissioning and handover.
Inspection, rebuild and recommission
Full overhaul of reciprocating, screw and centrifugal compressors: stripped, inspected, measured against tolerance, rebuilt and proven on test before it goes back.
Fire-tube and water-tube boilers
Re-tubing, inspection and preventive maintenance for fire-tube and water-tube boilers, restoring thermal efficiency and keeping the plant safe and compliant.
Planned maintenance, breakdown response and upgrades
Planned and reactive maintenance for heating and cooling plant: routine service, breakdown response, and efficiency upgrades for plant that works but costs too much to run.
Spray-applied protective linings
Plural-component spray-applied polyurea: a 100% solids, zero-VOC membrane that gels in seconds and returns a tank, basin or deck to service in hours, not the days a conventional epoxy system needs.
How we work
Every service line runs through the same sequence, so you know what happens next and what is expected of you at each stage.
Step 1
We measure on site: load, footprint, water chemistry, access, and what the existing plant is actually doing rather than what its nameplate says.
Step 2
Thermal sizing and equipment selection, costed on what the plant will draw over its life rather than on purchase price alone.
Step 3
Shells, tube bundles, coils, ducting and spares built to drawing, so a replacement matches the plant it is going into.
Step 4
Rigged, connected, pressure tested and handed over with performance verified against the design figures.
Step 5
Planned maintenance and breakdown response, with spares held for the plant we already look after.
Send the duty, the site and anything written on the nameplate. An engineer replies with questions first, then a costed proposal.
Plant down right now? Call the breakdown line on +966 53 783 7389, any hour.
